TECHNOLOGY NEWS

Monitors with built-in quad bike or a changer. Are found in monitors with built-changer or a quad bike. Due to the ease of installation are used in simple installations are often installed by the user. Usually have 2 or 4 channels, and terms of use are equivalent to a simple quad outside. Buildings quad forces emergence of additional connectors: connectors such as alarm, automatic switch to the camera within which the motion has been detected, and to attach alarm. In front of the monitor appear on the selection keys camera key, quad (for inclusion in the division of the screen) and others. General view of the monitor. Knobs are used for the selection of the camera switching times. View of the rear wall - you can see video and audio input for 2 cameras, audio and video outputs such as the VCR and camera power outputs. right at the bottom of the image controls Monitor 6 "MB - 60 SC with a built-changer for 2 cameras For monitors equipped with a quad image resolution is for the EIA and CCIR standards, respectively, 640 x 480 (version for four-camera 320 x 240) and 640 x 512 (version for four-camera 320 x 256) points. Is used 8-bit processing, and screen refresh occurs 15 times per second. If you see a fullscreen view, the processing system is discarded, and the picture with the camera is fed directly to the input of the monitor. Most ATVs are black - and white. Dual monitors in CCTV ². Although the Dual-circuit television is rarely used but there are also monitors equipped with built-in amplifier with an acoustic speaker. In this case, it is also possible eavesdropping, if the camera or its holder is equipped with a microphone. There are cinch connector or a mini - 3.5 mm jack. This module requires that the audio input level contained within the 10 - 150mVp-p. On the front panel there is an extra volume control.